MSDS

IARC. Significant exposure is not anticipated during brush application or drying. Risk of overexposure depends on
duration and level of exposure to dust from repeated sanding of surfaces or spray mist and the actual
concentration of Titanium Dioxide in the formula.
May cause central nervous system disorder (e.g., narcosis involving a loss of coordination, weakness, fatigue,
mental confusion, and blurred vision) and/or damage. Reports have associated repeated and prolonged
occupational overexposure to solvents with permanent brain and nervous system damage. Overexposure to
xylene in laboratory animals has been associated with liver abnormalities, kidney, lung, spleen, eye and blood
damage as well as reproductive disorders. Effects in humans, due to chronic overexposure, have included liver,
cardiac abnormalities and nervous system damage.
Primary Route(s) Of Entry: Skin Contact, Skin Absorption, Inhalation, Ingestion, Eye Contact
First Aid - Eye Contact: Immediately flush eyes with plenty of water for at least 15 minutes holding eyelids open.
Get medical attention. Do NOT allow rubbing of eyes or keeping eyes closed.
First Aid - Skin Contact: Wash with soap and water. Get medical attention if irritation develops or persists.
First Aid - Inhalation: If you experience difficulty in breathing, leave the area to obtain fresh air. If continued
difficulty is experienced, get medical assistance immediately.
First Aid - Ingestion: Aspiration hazard: Do not induce vomiting or give anything by mouth because this material
can enter the lungs and cause severe lung damage. Get immediate medical attention.
Flash Point: -156 F (Setaflash)
Extinguishing Media: Film Forming Foam, Carbon Dioxide, Dry Chemical, Water Fog
Unusual Fire And Explosion Hazards: FLASH POINT IS LESS THAN 20 °. F. - EXTREMELY FLAMMABLE
LIQUID AND VAPOR! Perforation of the pressurized container may cause bursting of the can. Isolate from heat,
electrical equipment, sparks and open flame. Keep containers tightly closed. Water spray may be ineffective.
Closed containers may explode when exposed to extreme heat. Vapors may form explosive mixtures with air.
Vapors can travel to a source of ignition and flash back.
Special Firefighting Procedures: Evacuate area and fight fire from a safe distance.
Steps To Be Taken If Material Is Released Or Spilled: Contain spilled liquid with sand or earth. DO NOT use
combustible materials such as sawdust. Remove all sources of ignition, ventilate area and remove with inert
absorbent and non-sparking tools. Dispose of according to local, state (provincial) and federal regulations. Do not
incinerate closed containers.
Handling: Follow all MSDS/label precautions even after container is emptied because it may retain product
residues. Use only in a well-ventilated area. Avoid breathing vapor or mist. Wash thoroughly after handling. Wash
hands before eating.
Storage: Do not store above 120
°
F. Store large quantities in buildings designed and protected for storage of
Section 4 - First Aid Measures
Section 5 - Fire Fighting Measures
Section 6 - Accidental Release Measures
Section 7 - Handling And Storage
Page
2
of
6
214084 STRUST +SSPR 6PK GLOSS ORANGE
6/14/2011
file://O:\Program%20Files\ProductVision%204.0\REPORTS\~PV63218.htm