Use and Care Manual

TECHNICAL DATA
SPC-15
RUST-OLEUM
®
TUB & TILE REFINISHING KIT
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 877∙385∙8155
www.rustoleum.com
Form: GDH-335
Rev.: 091922
PHYSICAL PROPERTIES
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.
TUB & TILE REFINISHING KIT
Resin Type
Epoxy Acrylic
Pigment Type
Titanium Dioxide
Solvents
Ethyl Benzene, Light Aromatic Naphtha, Propylene Glycol Monomethyl Ether,
1,2,4-Trimethylbenzene, 1,3,5-Trimethylbnezene, Xylene
Weight
Per Gallon
9.9 lbs.
Per Liter
1.19 kg
Solids
By Weight
54.6 %
By Volume
44.4 %
Volatile Organic Compounds
540 g/l (4.50 lbs./gal.)
Recommended Dry Film Thickness
(DFT) per Coat
1.5-2.0 mils
(37.5-50µ)
Wet Film to Achieve DFT
(unthinned material)
3.5-5.0 mils
(87.5-125µ)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
2 coats covers 70-110 sq. ft./quart or
2 coats on a standard bathtub
Pot Life
Up to 6 hours
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
1 hour
Recoat
1-2 hours
Full Cure
3 days
Dry Heat Resistance
NA
Shelf Life
3 years
Flash Point
78°F (26°C)
Safety Information
For additional information, see SDS