Use and Care Manual

TECHNICAL DATA
PEEL STOP –
SPECIALTY DRY ERASE QUART
Rust-Oleum Corporation Form: GDH-477
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 092214
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
DRY ERASE (WHITE, ACTIVATED)
Resin Type
Epoxy
Pigment Type
Titanium Dioxide
Solvents
Water, Glycol
Weight
Per Gallon
9.6 lbs
Per Liter
1.15 kg
Solids
By Weight
43.3%
By Volume
36.5%
Volatile Organic Compounds
<100 g/l (0.83 lbs./gal.)
Recommended Dry Film Thickness
(DFT) per Coat
2.0-2.5 mils
(50-62.5µ)
Wet Film to Achieve DFT
(unthinned material)
5.5-7.0 mils
(112.5-175µ)
Theoretical Coverage at
1 mil DFT (25µ)
146 sq.ft. /quart
Practical Coverage at Recommended
DFT (assumes 15% material loss)
(2 coats) 45-55 sq.ft./quart
Mixing Ratio
8 ounces of Part A to 19 ounces of Part B
Pot Life
1 hour
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
1 hour
Recoat
20-30 minutes
Full Cure
2 days
Shelf Life
1 year
Flash Point
>102°F (39°C)
Safety Information
For additional information, see MSDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.