Use and Care Manual

TECHNICAL DATA
PEEL STOP –
SPECIALTY GLOW IN THE DARK
Rust-Oleum Corporation Form: CS2870
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 082313
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
GLOW IN THE DARK
Resin Type
Modified Acrylic Copolymer
Pigment Type
Modified Zinc Copper Chloride
Solvents
Propylene Glycol, Water
Weight
Per Gallon
9.34 lbs
Per Liter
1.12 kg
Solids
By Weight
36.1%
By Volume
28.4%
Volatile Organic Compounds
130 g/l
1.08 lbs./gal.
Recommended Dry Film
Thickness (DFT) per Coat
1.5-2.5 mils
(37.5-62.5µ)
Wet Film to Achieve DFT
(unthinned material)
5.5-9.0 mils
(137.5-225µ)
Theoretical Coverage at
1 mil DFT (25µ)
25 sq.ft./can (7 oz.)
(0.6 m
2
/l)
Practical Coverage at
Recommended DFT
(assumes 15% material loss)
8-14 sq.ft./can (7 oz.)
(0.2-0.3 m
2
/can)
Dry Times at
70°F (21°C) and
50% Relative
Humidity
Touch
45 minutes
Handle
2 hours
Recoat
45 hours
Shelf Life
5 years
Flash Point
200°F (93°C)
Safety Information
For additional information, see MSDS.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.