Use and Care Manual
TECHNICAL DATA SPC-28
SPECIALTY
TEXTURED PLASTIC SPRAY
Form: GDH-392
Rev.: 072814
1
.DESCRIPTION AND USES .
Rust-Oleum
®
Textured Plastic Spray is designed to renew
the appearance of indoor and outdoor plastics. No primer
is required. These sprays are ideal for use on
polypropylene, polystyrene, resin, PVC, fiberglass, and
vinyl plastics such as chairs, tables, and planters. Some
plastics made of polyethylene such as Little Tikes
®
children’s products are manufactured in a way that may
hinder maximum paint adhesion. Test this product in an
inconspicuous area to test for compatibility on the surface.
.PRODUCTS .
SKU Description
223718 Forest Green
223719 Sandstone
223717 Black
223780 White
. APPLICATION .
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when temperatures are between 50-90ºF (10-
32ºC) and humidity is below 65% to ensure proper drying.
Avoid spraying in very windy and dusty conditions. Cover
surrounding area to protect from spray mist.
SURFACE PREPARATION
For new plastic surfaces, thoroughly wipe down surface
with paint thinner to promote adhesion. For aged or
weathered surfaces, remove loose material with a brush or
scraper, clean with soap and water, rinse and let dry.
Sanding may be required for glossy or smooth surfaces. If
mildew is present, wash with a bleach solution, rinse and
let dry.
WARNING! If you scrape, sand, or remove old paint, you
may release lead dust. LEAD IS TOXIC. EXPOSURE TO
LEAD DUST CAN CAUSE SERIOUS ILLNESS SUCH AS
BRAIN DAMGE, ESPECIALLY IN CHILDREN.
PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH approved respirator to
control lead exposure. Clean up carefully with a HEPA
vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the
U.S.EPA/Lead Information Hotline at 1-800-424-LEAD or
log on to www.epa.gov/lead.
.PRODUCT APPLICATION (cont.) .
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during
use. Hold can upright 10-16” from surface and spray in a
steady back-and-forth motion, slightly overlapping each
stroke. Keep the can the same distance from the surface
and in motion while spraying. Apply 2 or more light coats a
few minutes apart. Two or more coats may be necessary
to ensure all corners and edges are adequately covered.
Do not use near open flame.
DRY & RECOAT TIMES
Dry and recoat times are based on 70ºF and 50% relative
humidity. Allow more time at cooler temperatures. Dries to
touch in 20-30 minutes, to handle in 1 hour and is fully dry
in 24 hours. Apply a second coat within 1 hour or after 48
hours. Maximum adhesion is achieved in 5-7 days.
CLEAN-UP
When finished spraying, clear spray valve by turning the
can upside down and pushing the nozzle for 5 seconds.
Clean-up wet paint with xylene or mineral spirits. Properly
discard empty container. Do not burn or place in home
trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into can valve opening.