Use and Care Manual

TECHNICAL DATA
RSD-02
ROCKSOLID
®
METALLIC
GARAGE FLOOR COATING KIT
3
Form: GDH-605
Rev.: 020119
PRODUCT APPLICATION (cont.)
COVERAGE RATE
Each Polycuramine pouch covers up to 100-125 square feet.
Coverage may vary based on condition and porosity of the
concrete.
DRY TIME
Temperature and humidity may affect drying time. Do not
walk on the coating while it is still tacky. Surface should be
ready for foot traffic in 8-10 hours and vehicle traffic in 24-36
hours depending upon temperature and humidity.
CLEAN-UP
Clean tools and equipment with acetone. Allow unused
product to harden in container and dispose according to
local regulations.
THINNING
None required
LIMITATIONS
This product must be installed at the specified spread rates
to perform as described. Do not apply in direct sunlight. Do
not apply product when the substrate and ambient
temperatures are steadily below 40°F (4°C).
SHELF LIFE and STORAGE
Sixty (60) months in factory delivered unopened pouches.
Keep away from extreme heat, cold and moisture. Maintain
at a proper storage temperature of 45-90°F. Keep out of
direct sunlight and away from fire hazards.
PERFORMANCE CHARACTERISTICS
FLEXIBLITY (1/8” MANDREL)
METHOD: ASTM D1737
RESULT: Pass
HARDNESS SHORE D
METHOD: ASTM D2240
RESULT: 90
GLOSS @ 60°
METHOD: ASTM D523
RESULT: >95
ABRASION RESISTANCE
METHOD: ASTM 4060, CS 17, 1,000 gram load
RESULT: Loss/1000 cycles = 40 mg