Use and Care Manual

TECHNICAL DATA
ROCKSOLID
®
POLYCURAMINE
®
GARAGE FLOOR COATING KIT
Form: GDH-604
Rev.: 082416
2
.PRODUCT APPLICATION (cont.) .
MIXING (cont.)
Combine the two components by placing the pouch on the
ground and rolling it from the part A side towards the part
B side like a tube of toothpaste. This will create pressure
in the part A side and force the middle seal to burst,
allowing the two components to mix together. Thoroughly
mix the materials by shaking the pouch back and forth and
squeezing the edges and corners toward the center of the
pouch. Mix for 2-3 minutes.
APPLICATION
Apply only when air, material and floor temperatures are
between 40-90°F (4-32°C). Optimal installation
temperature is 55-90°F (13-32°C). Extreme cold
application temperatures may slow the cure time. Do not
apply in direct sunlight. Do not coat the floor if it is
raining or if extremely damp conditions exist. The concrete
surface must be completely dry at the time of the
application to achieve proper adhesion.
Once the material in thoroughly mixed, use a scissors to
cut a corner off the pouch. Pour the contents of the pouch
directly onto the floor in a 2-3” wide ribbon about 4’ long.
Trim the edges from the poured ribbon of material using a
good quality synthetic brush. Use the supplied RockSolid
⅜” Microfiber Roller Cover on a 9” roller frame to apply
the coating evenly to the floor in 4’ x 4’ sections in an “M”
and “W” pattern. Continue working in 4’ x 4’ sections,
pouring a new ribbon 2’ away from the previous section.
Use the roller to pull the material back first; then push
forward to fill in the void between sections. Overlap into
the previously coated areas while taking care to avoid
creating thick spots.
Once a strip across the entire back wall has been coated,
toss the decorative paint chips onto the wet coating. Leave
a 6”-12” section of wet film without decorative chips. This
section will be rolled into when coating the next 4’ x 4’
area. Skip this step if paint chips are not desired. The
coating performance will not be affected.
Do not coat or roll over control joints. Use a flexible control
joint fill material if desired. Repeat the above steps for
each additional pouch.
COVERAGE RATE
Each Polycuramine pouch covers up to 200-250 square
feet. Coverage may vary based on condition and porosity
of the concrete.
DRY TIME
Temperature and humidity may affect drying time. Do not
walk on the coating while it is still tacky. Surface should be
ready for foot traffic in 8-10 hours and vehicle traffic in 24-
36 hours depending upon temperature and humidity.
.PRODUCT APPLICATION (cont.) .
CLEAN-UP
Clean tools and equipment with mineral spirits. Allow
unused product o harden in container and dispose
according to local regulations.
LIMITATIONS
This product must be installed at the specified spread
rates to perform as described. Do not apply in direct
sunlight. Do not apply product when the substrate and
ambient temperatures are steadily below 40°F (4°C).
SHELF LIFE and STORAGE
Twenty-four (24) months in factory delivered unopened
pouches. Keep away from extreme heat, cold and
moisture. Maintain at a proper storage temperature of 45-
90°F. Keep out of direct sunlight and away from fire
hazards.
.PERFORMANCE CHARACTERISTICS .
Flexibility, ⅛” Mandrel (ASTM D1737) Pass
Hardness, Shore D (ASTM D2240) 90
Gloss (ASTM D523) @ 60° >95
Abrasion Resistance (ASTM D4060)
CS-17 Wheel, 1,000 g load, 1,000 cycles 40 mg