Manualshelf

Instructions / Assembly

ManualsBrandsRust-Oleum Restore ManualsPaint1-gal. Graywash Solid Acrylic Exterior Concrete and Wood Stain
12
TECHNICAL DATA RST-04
RESTORE
™
SOLID ACRYLIC STAIN
Form: GDH-100
Rev.: 082415
1
DESCRIPTION AND USES .
Restore
™
Solid Acrylic Stain is formulated to for bare concrete
and wood surfaces. It is suitable for application to decks, railings,
fences, siding, trim, retaining walls and more. Use it to match the
color of surfaces coated with Restore™ Deck & Concrete. Do
not apply Solid Acrylic Stain to any surface that has been coated
with paint, stain or water repellent except surfaces coated with
Restore Deck & Concrete.
.PRODUCTS .
SKU Description
47021 1-Gallon Solid Acrylic Stain Cape Cod Gray
47026 1-Gallon Solid Acrylic Stain Timberline
..PRODUCT APPLICATION .
SURFACE PREPARATION
Proper surface preparation is critical to performance. Surface
must be clean and free of dirt, grease, mildew and organic
growth to ensure product bonding and adhesion. Sand or scrape
any loose paint. Smooth or glossy surfaces should be sanded or
roughed-up prior to application of Solid Acrylic Stain. Clean the
surface using a brush and Restore Deck & Concrete Cleaner or
suitable non-bleach cleaner.
..PRODUCT APPLICATION (cont.)
APPLICATION
Apply when ambient air and surface temperatures are between
50-90°F (10-32°C) and the relative humidity is less than 85%. Do
not apply if temperatures are expected to drop below 40°F or if
rain or snow is expected within 24 hours.
Thoroughly power mix prior to application and stir occasionally
during application. Box material if using more than one container
to ensure color consistency. Restore Solid Acrylic Stain is ready
to use. Do not thin or mix with any other stains or paints.
Brushing out a sample is recommended to ensure color
satisfaction. Apply by brush, roller or spray. When applying to
wood, thoroughly coat all cut ends and joints. For best results,
apply in the shade.
Two coats are recommended for maximum durability.
DRY TIMES
Dries to the touch in 1 hour and can be recoated in 2 hours. Full
cure can be expected in 24 hours. Longer dry time is required in
cooler temperatures and at higher humidity
CLEAN-UP
When finished, wash tools and equipment with mild soap
and warm water. Properly dispose of all soiled rags and
protect unused product from freezing.

Summary of content (2 pages)