Use and Care Manual

TECHNICAL DATA
RESTORE
®
OUTDOOR FURNITURE
2 Form: GDH-691
Rev.: 030717
PRODUCT APPLICATION (cont) .
APPLICATION
TWO THICK COATS OF OUTDOOR FURNITURE ARE
RECOMMENDED.
Thoroughly mix the material to ensure any settled pigment is re-
dispersed and stir occasionally during use. When using more
than one container, combine all containers to ensure color
consistency.
Using either a 4” wide ⅜” or ½” nap roller or a synthetic paint
brush, saturate and apply generously in a consistent pattern.
Work to a wet edge at all times. Avoid rolling back into coated
areas where drying has begun. If needed, use a putty knife or
other straight edge to remove excess coating between boards.
Allow the coating to dry 4-6 hours. Extend drying time if the
surface is tacky or soft. Drying times may vary depending on
temperature and humidity. Apply a second coat following the
above procedure. Allow the second coat to dry 24 hours before
light use and 3-5 days for heavy use. Full cure to a hard finish will
take approximately 3-4 weeks.
PRODUCT APPLICATION (cont) .
DRY TIMES
Dries to the touch in 2-4 hours. Longer dry time is required in
cooler temperatures and at higher humidity. Surface is ready for
light use in 24 hours and 3-5 days before heavy use. Full cure to
a hard finish will take approximately 3-4 weeks.
COVERAGE
1 gallon covers up to 80 square feet with two coats.
CLEAN-UP
Restore Outdoor Furniture is a water-based product that
will clean up with soap and water. For best results, clean
up should be done before the product dries. Properly
dispose of all soiled rags and protect unused product from
freezing.