Use and Care Manual

TECHNICAL DATA
PROFESSIONAL ACRYLIC LATEX BRUSH
Rust-Oleum Corporation Form: GDH-414
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 080614
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
FINISHES
PRIMER
Resin Type
Water-based Acrylic
Water-based Acrylic
Pigment Type
Carbon Black, Titanium Dioxide
Red Iron Oxide, Zinc Phosphate
Solvents
Water, Glycol Ethers
Water, Glycol Ethers
Weight
Per Gallon
8.6-9.8 lbs.
10.1 lbs.
Per Liter
1.03-1.17 kg
1.21 kg
Solids
By Weight
35.7-45.0%
49.9%
By Volume
33.3-35.0%
38.9%
Volatile Organic Compounds
<250 g/l
2.08 lbs./gal.
<250 g/l
2.08 lbs./gal.
Recommended Dry Film Thickness
(DFT) per Coat
1.5 – 2.5 mils
(37.5-62.5µ)
1.5 - 2.5 mils
(37.5-62.5µ)
Wet Film to Achieve DFT (unthinned
material)
4.5-7.5 mils
(112.5-187.5µ)
4.0-6.5 mils
(100-162.5µ)
Theoretical Coverage at 1 mil DFT
(25µ)
534-561 sq.ft. /gal.
(13.1-13.8 m
2
/l)
624 sq.ft./gal.
(15.4 m
2
/l)
Practical Coverage at
Recommended DFT
(assumes 15% material loss)
190-300 sq.ft./gal.
(4.7-7.4 m
2
/l)
200-350 sq.ft./gal
(4.9-8.6 m
2
/l)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
30 minutes
30 minutes
Handle
1 hour
1 hour
Recoat
2-4 hours
2-4 hours
Dry Heat Resistance
200ºF (93ºC)
200ºF (93ºC)
Shelf Life
5 years
5 years
Flash Point
<150ºF (65ºC)
<150ºF (65ºC)
Safety Information
For additional information, see MSDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.