Use and Care Manual

TECHNICAL DATA PRO-12
PROFESSIONAL
ACRYLIC LATEX BRUSH
Form: GDH-414
Rev.: 080614
1
.DESCRIPTION AND USES .
Rust-Oleum
®
Professional Acrylic Latex brush is designed to
provide long lasting protection and durability. This enamel offers
excellent coverage, chip resistance and color retention.
.PRODUCTS .
SKU Description
246939 Black
246970 White
246971 Red Primer
..PAINTING CONDITIONS .
Apply only when air and surface temperatures are above 50ºF
(10ºC) and 90ºF (32ºC) and humidity is below 85% to ensure
proper drying.
..PRODUCT APPLICATION .
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants by
washing the surface with a commercial detergent, or other
suitable cleaning method. Rinse with fresh water and allow to
thoroughly dry. Remove loose paint and rust with a wire brush or
sandpaper. Lightly sand glossy surfaces. WARNING! If you
scrape, sand, or remove old paint, you may release lead dust.
LEAD IS TOXIC. Contact the U.S.EPA/Lead Information Hotline
at 1-800-424-LEAD or log on to www.epa.gov/lead.
..PRODUCT APPLICATION (cont.) .
APPLICATION
Before using, stir thoroughly to ensure any settled pigment is re-
dispersed. Thinning is not required. In hot, dry conditions, thin
with up to 2 ounces of water per quart to extend dry time. Avoid
painting in direct sunlight or on hot surfaces. Use a good quality
synthetic brush. Avoid excessive brushing as this will reduce film
thickness and protection. Use light even strokes to ensure
smooth and uniform flow.
DRY & RECOAT TIMES
Dry and recoat times are based on 70ºF and 50% relative
humidity. Allow more time at cooler temperatures. Dries to touch
in 30 minutes, to handle in 1 hour, and is fully dry in 2-4 hours.
Primers may be top coated after 2-4 hours.
CLEAN-UP
Clean brush and other application tools immediately with soap
and water.