Use and Care Manual

TECHNICAL DATA
PROFESSIONAL ENAMEL SPRAYS
Rust-Oleum Corporation Form: GDH-749
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 031215
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
FINISHES
ALUMINUM
Resin Type
Modified Alkyd
Acrylic Polymer
Fill Weight
15 oz.
14 oz.
MIR
Primers and Flats – 1.20 Max
Non-Flats – 1.40 Max
1.90 Max
Practical Coverage at Recommended
DFT (assumes 15% material loss)
Approximately 14 sq. ft./can
(1.3 m
2
/can)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
15 minutes
Handle
1-2 hours
Recoat
Within 1 hour or after 48 hours (7515, 7569 and 7582, recoat at any time)
Dry Heat Resistance
200°F (93°C)
Shelf Life
5 years
Flash Point
-156°F (-104°C)
Safety Information
For additional information, see MSDS.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.