Use and Care Manual

TECHNICAL DATA
PRO FINISHER WATER-BASED SANDING SEALER
Rust-Oleum Corporation Form: GDH-813
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 051217
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
PRO FINISHER WATER-BASED SANDING SEALER
Resin Type
Acrylic
Pigments
NA
Solvents
Diethylene Glycol Monobutyl Ether, Water
Weight
Per Gallon
8.54 lbs
Per Liter
1.02 kg
Solids
By Weight
28.6%
By Volume
26.5%
Volatile Organic Compounds
162 g/l (1.35 lbs. /gal.)
Recommended Dry Film Thickness
(DFT) per Coat
0.5-1.0 mils
(12.5-25µ)
Wet Film to Achieve DFT (unthinned
material)
2.0-4.0 mils
(50-100µ)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
550 sq.ft./gal.
(13.5 m²/l)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
30-45 minutes
Recoat
1 hour
Light Traffic
24 hours
Full Cure
7 days
Shelf Life
3 years
Flash Point
>220°F (104°C)
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.