Use and Care Manual

TECHNICAL DATA
SUPER GLAZE
Rust-Oleum Corporation Form: GDH-693
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 080117
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
Resin Type
Epoxy – Amine
Weight*
Per Gallon
8.8 lbs.
Per Liter
1.05 kg
Solids*
By Weight
94.5%
By Volume
95.2%
Volatile Organic Compounds*
<100 g/l
Mixing Ratio
1:1 Base to Activator (by volume)
Recommended Dry Film
Thickness (DFT) per Coat
61.5 mils
Wet Film to Achieve DFT (Unthinned
material)
64.6 mils
Practical Coverage at recommended
film thickness (assumes 15% material
loss)
5.25 sq.ft./quart
Pot Life @70ºF (21ºC)
and 50% Relative Humidity
20-25 minutes
Dry Times at 70-80°F
(21-27ºC) and 50%
Relative Humidity
Touch
4-5 hours
Full Cure
72 hours
Shelf Life
2 years
Flash Point
Base Component 294°F (146°C) – Activator Component 181°F (83°C)
Safety Information
For additional information, see SDS
* Activated material.
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.