Use and Care Manual

TECHNICAL DATA
PKS-01
PRO FINISHER POLYURETHANE
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 800∙901∙0411
www.rustoleum.com
Form: GDH-558
Rev.: 110119
PHYSICAL PROPERTIES
PRO FINISHER POLYURETHANE
Resin Type
Oil modified Polyurethane
Pigments
NA
Solvents
Mineral Spirits
Weight
Per Gallon
8.75-8.80 lbs.
Per Liter
1.04-1.05 kg
Solids
By Weight
40.1-41.7%
By Volume
25.8-27.0%
Volatile Organic Compounds
450 g/l (3.75 lbs./gal.)
Recommended Dry Film Thickness
(DFT) per Coat
1.0-2.0 mils
(25-50µ)
Wet Film to Achieve DFT
(unthinned material)
3.5-7.0 mils
(87.5-175µ)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
300-400 sq.ft./gal.
Depends on surface porosity and method of application
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
3-6 hours
Recoat
6-10 hours
Shelf Life
3 years
Flash Point
93° F (34°C)
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.