Use and Care Manual

TECHNICAL DATA
PRO FINISHER POLYURETHANE
Rust-Oleum Corporation Form: GDH-558
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 103014
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
Pro Finisher Polyurethane Finish
Resin Type
Oil modified Polyurethane
Pigments
NA
Solvents
Mineral Spirits
Weight
Per Gallon
8.75-8.80 lbs.
Per Liter
1.04-1.05 kg
Solids
By Weight
40.1-41.7%
By Volume
25.8-27.0%
Volatile Organic Compounds
450 g/l
(3.75 lbs./gal.)
Recommended Dry Film Thickness
(DFT) per Coat
1.0-2.0 mils
(25-50µ)
Wet Film to Achieve DFT (unthinned
material)
3.5-7.0 mils
(87.5-175µ)
Theoretical Coverage at 1 mil DFT
(25µ)
413-433 sq.ft./gal.
Practical Coverage at Recommended
DFT (assumes 15% material loss)
300-400 sq.ft./gal.
(Varies with surface porosity)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
3-6 hours
Recoat
6-10 hours
Shelf Life
3 years
Flash Point
93° F (34°C)
Safety Information
For additional information, see MSDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.