Use and Care Manual

TECHNICAL DATA
PEEL STOP –
NEVERWET
™
FABRIC WATER REPELLING TREATMENT
Rust-Oleum Australia Pty, Ltd. HAYDN BRUSH CO. LTD. Form: GDH-587
Unit 12, 4 Southridge Street PO Box 4325 Rev.: 121614
Eastern Creek, NSW 2766 Christchurch, New Zealand
PH: 1 300 784 476 PH: 64 3 384 7770
www.rustoleum.com.au email: [e-mail]
email: [e-mail]
.PHYSICAL PROPERTIES .
NEVERWET FABRIC
Resin Type
Silicone
Pigment Type
NA
Solvents
Mineral Spirits
Weight per Liter
0.79 kg
Fill Weight
325 mL
VOC
710 g/l
Practical Coverage at Recommended
DFT (assumes 15% material loss)
Coverage will vary depending on fabric
5.5 m
2
on smooth/light fabrics to 2 m
2
on textured/heavy fabrics
Dry Times at 21-27ºC and
50% Relative Humidity
Touch
Varies depending on fabric
Handle
Varies depending on fabric
Full Cure
Allow to dry 24 hours before exposing to water
Shelf Life
2 years
Flash Point
24°C
Safety Information
For additional information, see MSDS.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.