Use and Care Manual

TECHNICAL DATA
MARINE COATINGS BOAT BOTTOM ANTIFOULING PAINT
Rust-Oleum Corporation Form: GDH-163
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 091613
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSL t
BOAT BOTTOM ANTIFOULING PAINT
Resin Type
Modified Epoxy
Pigment Type
Carbon Black and Cuprous Oxide
Solvents
Aromatic Hydrocarbons
Weight
Per Gallon
15.0 lbs.
Per Liter
1.80 kg
Solids
By Weight
74-80%
By Volume
51-59%
Volatile Organic Compounds
440 g/l Max
Recommended Dry Film
Thickness (DFT) Per Coat
2.0 mils
Wet Film to Achieve DFT
(unthinned material)
3.5 mils
Theoretical Coverage at
1 mil DFT (25µ) sq.ft./gal
220 sq.ft./quart
Practical Coverage at Recommended DFT
(sq.ft./gal) (assumes 15% material loss)
110 ft
2
/quart
Dry Times at 70°F
(21°C) and 50%
Relative Humidity
Recoat
4 hours
To Launch
16 hours
Shelf Life
2 years
Flash Point
114°F (46°C)
Safety Information
For additional information, see MSDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.