Use and Care Manual

TECHNICAL DATA
EPOXYSHIELD
®
WATER-BASED EPOXY GARAGE FLOOR COATING
Rust-Oleum Corporation Form: GDH-356
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 100516
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
WATER-BASED EPOXY GARAGE FLOOR COATING
Resin Type
Amine cured Epoxy
Pigment Type
Varies with color
Solvents
Ethylene Glycol Monopropyl Ether, Water
Weight*
Per Gallon
10.50-10.60 lbs.
Per Liter
1.25-1.27 kg
Solids*
By Weight
62.6-63.3%
By Volume
52.6-52.8%
Volatile Organic Compounds*
<100 g/l (0.80 lbs./gal.)
Mixing Ratio
3:1 Base to Activator by volume
Recommended Dry Film
Thickness (DFT) per Coat
3.0-3.5 mils
(75-87.5µ)
Wet Film to Achieve DFT (Unthinned
material)
6.0-7.0 mils
(150-175µ)
Theoretical Coverage at
1 mil DFT (25µ)
844-847 sq.ft./gal.
(20.7-20.8 m
2
/l)
Practical Coverage at Recommended DFT
(assume 15% material loss)
Approximately 250 sq.ft./kit.
(6.2 m
2
/l)
Induction Period
Varies with temperature – See chart in directions
Pot Life @ 70-80ºF (21-27ºC) and
50% Relative Humidity
Varies with temperature – See chart in directions
Dry Times at 70-80°F
(21-27ºC) and 50%
Relative Humidity
Foot Traffic
24 hours
Vehicle Traffic
3 days
Shelf Life
5 years
Flash Point
>200°F (93°C) activated material
Safety Information
For additional information, see SDS
Calculated values may vary slightly from the actual manufactured material.
*Activated material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.