SDS

Date Printed: 9/17/2015
8. Exposure Controls/Personal Protection
Chemical Name CAS-No.
Weight %
Less Than
ACGIH TLV-
TWA
ACGIH TLV-
STEL
OSHA PEL-TWA
OSHA PEL-
CEILING
Aliphatic Polyamine PROPRIETARY 20.0 N.E. N.E. N.E. N.E.
Limestone 1317-65-3 20.0 N.E. N.E. 15 mg/m3 N.E.
Titanium Dioxide 13463-67-7 20.0 10 mg/m3 N.E. 15 mg/m3 N.E.
2-Propenenitrile, reaction
products with 3-amino-1,5,5-
trimethylcyclohexanemethanami
ne
90530-15-7 5.0 N.E. N.E. N.E. N.E.
Ethylene Glycol Monopropyl
Ether
2807-30-9 5.0 N.E. N.E. N.E. N.E.
Benzene-1,3-dimethaneamine
(MXDA)
1477-55-0 1.0 N.E. N.E. N.E. N.E.
Amorphous Silica 7631-86-9 1.0 N.E. N.E. N.E. N.E.
PERSONAL PROTECTION
ENGINEERING CONTROLS: Use process enclosures, local exhaust ventilation, or other engineering controls to control airborne
levels below recommended exposure limits. Provide general dilution of local exhaust ventilation in volume and pattern to keep TLV of
hazardous ingredients below acceptable limits. Prevent build-up of vapors by opening all doors and windows to achieve cross-
ventilation.
RESPIRATORY PROTECTION: A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2 requirements must be
followed whenever workplace conditions warrant a respirator's use.
SKIN PROTECTION: Use gloves to prevent prolonged skin contact. Use impervious gloves to prevent skin contact and absorption of
this material through the skin. Nitrile or Neoprene gloves may afford adequate skin protection.
EYE PROTECTION: Use safety eyewear designed to protect against splash of liquids.
OTHER PROTECTIVE EQUIPMENT: Refer to safety supervisor or industrial hygienist for further guidance regarding types of
personal protective equipment and their applications. Refer to safety supervisor or industrial hygienist for further information
regarding personal protective equipment and its application.
HYGIENIC PRACTICES: Wash thoroughly with soap and water before eating, drinking or smoking. Remove contaminated clothing
immediately and launder before reuse.
9. Physical and Chemical Properties
Appearance:
Liquid
Physical State:
Liquid
Odor:
Mild
Odor Threshold:
N.E.
Relative Density:
1.338
pH:
N.D.
Freeze Point, °C:
N.D.
Viscosity:
N.D.
Solubility in Water:
Miscible
Partition Coefficient, n-octanol/
water:
N.D.
Decompostion Temp., °C:
N.D.
Boiling Range, °C:
90 - 153
Explosive Limits, vol%:
1.3 - 15.8
Flammability:
Does not Support Combustion
Flash Point, °C:
94
Evaporation Rate:
Slower than Ether
Auto-ignition Temp., °C:
N.D.
Vapor Density:
Heavier than Air
Vapor Pressure:
N.D.
(See "Other information" Section for abbreviation legend)
10. Stability and Reactivity
CONDITIONS TO AVOID: Avoid temperatures above 120°F (49°C). Avoid contact with strong acid and strong bases. Avoid contact
with metals.
INCOMPATIBILITY: Incompatible with strong oxidizing agents, strong acids and strong alkalies. Product slowly corrodes copper,
aluminum, zinc, and galvanized surfaces.
HAZARDOUS DECOMPOSITION: When heated to decomposition, it emits acrid smoke and irritating fumes. Decomposition
produces hydrogen chloride, chlorine and hydrogen gases.
HAZARDOUS POLYMERIZATION: Will not occur under normal conditions.
STABILITY: This product is stable under normal storage conditions.
Page 3 / 5