Use and Care Manual

TECHNICAL DATA
EPOXYSHIELD
®
CLEAR FINISH FLOOR COATING KIT
Rust-Oleum Corporation Form: GDH-1073
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 031716
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
Resin Type
Amine Cured Epoxy
Pigment
None
Solvent
Benzyl Alcohol
Weight
Per Gallon
8.96 lbs.
Per Liter
1.07 kg
Solids
By Weight
100%
By Volume
100%
Volatile Organic Compounds
<75 g/l
Mixing Ratio
5:3 Base : Base to Activator by Volume
Pot Life @ 70-80°F (21-27°C) & 50%
Relative Humidity
60 minutes
Recommended Dry Film Thickness (DFT)
per Coat
2.5-5.0 mils
(62.5-125µ)
Wet Film to Achieve DFT (unthinned
material)
2.5-5.0 mils
(62.5-125µ)
Practical Coverage at Recommended DFT
(assumes 15% material loss)
250 sq.ft./kit on bare concrete
500 sq.ft./kit on painted surfaces
Dry Times @ 70-80º F
(21-27°C) and 50%
Relative Humidity
†
Light Foot Traffic
12-16 hours
Heavy Foot Traffic
24-48 hours
Vehicle Traffic
3 days
Shelf Life
5 years
Flash Point
>200°F (93°C)
Safety Information
For additional information, see SDS
Calculated values are shown and may vary slightly from the actual manufactured material.
†
Dry times will be increase if temperatures are less than 55ºF (13ºC).
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.