Use and Care Manual

TECHNICAL DATA
EPOXYSHIELD
®
PENETRATING CONCRETE SEALER
Rust-Oleum Corporation Form: GDH-358
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 050614
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
PENETRATING CONCRETE SEALER
Resin Type
Proprietary Water-based Polymer
Pigment Type
None
Solvents
Glycol Ether, Water
Weight*
Per Gallon
8.33 lbs.
Per Liter
1.00 kg
Solids*
By Weight
Proprietary
By Volume
Proprietary
Volatile Organic Compounds*
<15 g/l (0.12 lbs./gal.)
Recommended Dry Film
Thickness (DFT) Per Coat
Penetrating Sealer – No surface film
Wet Film to Achieve DFT
(Unthinned Material)
2 saturating coats
Theoretical Coverage at
1 mil DFT (25µ)
300-800 sq.ft./gal. (7.4-19.7 m
2
/l)
Depending on concrete porosity
Practical Coverage at Recommended DFT
(assumes 15% material loss)
200-700 sq.ft./gal. (6.2-17.2 m
2
/l)
Depending on concrete4 porosity
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Walk Ready
2 hours
Drive Ready
12 hours
Recoat
Optional: when surface wetness disappears and up to 2 days
Shelf Life
2 years
Flash Point
>200°F (93°C)
Safety Information
For additional information, see MSDS
Calculated values are shown and may vary slightly from the actual manufactured material
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.