Use and Care Manual

EPOXYSHIELD
®
STAIN ADDITIVE FOR LOW VOC PREMIUM CLEAR
TECHNICAL DATA
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature do not constitute
a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we can guarantee these products only
to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All technical information is subject to change without notice.
Form: CS983
Rev.: 071712
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
An RPM Company
Phone: 877
•
385
•
8155
www.rustoleum.com/industrial
®
PHYSICAL PROPERTIES
STAIN ADDITIVE KIT
Resin Type
Amine cured epoxy
Solvents
Methyl Acetate
Weight*
Per Gallon
9.1-9.4 lbs.
Per Liter
1.09-1.13 kg
Solids*
By Weight
71.4-82.3%
By Volume
72.2-79.5%
Volatile Organic Compounds*
<50g/l (0.42 lbs/gal)
Mixing Ratio
8 oz. stain additive per 120 oz. clear base
Recommended Dry Film
Thickness (DFT) Per Coat
2.0-5.0 mils (50-125µ)
Wet Film to Achieve DFT
(Unthinned Material)
3.0-7.0 mils (75-175µ)
Theoretical Coverage at
1 mil DFT (25µ)
1158-1275 sq.ft./gal
(28.0-31.0 m
2
/l)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
500 sq.ft./gal. (23 m
2
/l) painted surfaces
250 sq.ft./gal. (46 m
2
/l) bare concrete
Induction Period
None
Pot Life @ 70-80°F (21-27°C)
and 50% Rel. Hum.
90 minutes
Dry Times
at 70-80°F
(21-27°C) and
50% Rel. Hum.
Lt. Foot Traffic
10 hours
Hv. Foot Traffic
24 hours
Vehicle Traffic
4 days
Shelf Life
2 years
Safety
Information
Flash Point
32ºF (0ºC)
Safety
FOR ADDITIONAL INFORMATION, SEE MSDS.
Calculated values may vary slightly from the actual manufactured material.
*Activated material.