Use and Care Manual

TECHNICAL DATA
EPOXYSHIELD
®
LOW VOC WATER-BASED EPOXY GARAGE FLOOR COATING
Rust-Oleum Corporation Form: CS2291
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 041913
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
LOW VOC WATER-BASED EPOXY GARAGE FLOOR COATING
Resin Type
Amine cured epoxy
Pigment Type
Varies with color
Solvents
Ethylene glycol Monopropyl ether, Water
Weight*
Per Gallon
10.50-10.60 lbs.
Per Liter
1.25-1.27 kg
Solids*
By Weight
62.6-63.3%
By Volume
52.6-52.8%
Volatile Organic Compounds*
<50g/l (0.42 lbs./gal.)
Mixing Ratio
92.5 fl.oz.:27.5 fl.oz. Base to Activator (by volume)
Recommended Dry Film
Thickness (DFT) per Coat
3.0-3.5 mils (75-87.5µ)
Wet Film to Achieve DFT (Unthinned
material)
6.0-7.0 mils (150-175µ)
Theoretical Coverage at
1 mil DFT (25µ)
791-794 sq.ft./gal.
(19.5-19.6 m
2
/l)
Practical Coverage at
Recommended DFT (assume 15%
material loss)
Approximately 250 sq.ft./kit.
(23 m
2
/l)
Induction Period
Varies with temperature – See chart in directions
Pot Life @70-80ºF (21-27ºC)
and 50% Relative Humidity
Varies with temperature – See chart in directions
Dry Times at 70-
80°F (21-27ºC) and
50% Relative
Humidity
Foot Traffic
12 hours
Vehicle Traffic
5 days
Shelf Life
5 years
Flash Point
200°F (93°C) Activated material
Safety Information
For additional information, see MSDS
Calculated values may vary slightly from the actual manufactured material.
*Activated material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.