Use and Care Manual

Form: CS1077

Rev.: 061812

EPOXYSHIELD

1-PART CONCRETE PAINT

TECHNICAL DATA

PRODUCT APPLICATION (cont.)

MIXING

Mix thoroughly to re-disperse to ensure any settled pigment is

re-dispersed. Do not mix the color chips in with the coating.

APPLICATION

Apply only when air, material, and surface temperatures are

between 60-85°F (15-29°C) and the surface temperature is

at least 5°F (3°C) above the dew point. The relative humidity

should not be greater than 85%. Stir thoroughly. Cut in the

perimeter of the ﬂoor along the wall, or other areas where a

roller cannot reach, using a brush or edger before beginning

roller application. Use a synthetic ½" nap roller cover on a 9"

roller frame to apply an even coat of EPOXYShield

Concrete

Paint onto the surface. Limit the application to 4x4 foot

(1.2x1.2m) sections at a time. If decorative chips are used,

scatter the chips up and away from you so they land ﬂat on

the wet paint, then continue on to the next section. Note: Fresh

paint can be applied over the loose chips lying outside the

previously painted area. Maintain a wet edge to prevent lap

marks and gloss differences. Make all ﬁnal passes in the same

direction to help ensure uniform appearance. Only one coat

is necessary under most circumstances. Occasional touch-up

may be required in areas subject to heavy trafﬁc.

CLEAN-UP

Wash tools and equipment with warm water and a mild

detergent immediately after use. Properly dispose of all roller

covers and soiled rags