Use and Care Manual

TECHNICAL DATA
EPOXYSHIELD
®
2-PART CONCRETE RESURFACER
Rust-Oleum Corporation Form: CS565
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 091913
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
2-PART CONCRETE RESURFACER
Resin Type
Modified Acrylic
Solvents
Mineral Oil, Water, Liquid Polymer
Liquid Polymer
Mortar Mix
Weight*
Per Gallon
8.6 4 lbs.
29.2 lbs.
Per Liter
1.0 kg
3.5 kg
Solids*
By Weight
25.1%
100%
By Volume
23.2%
100%
Volatile Organic Compounds*
<250 g/l (2.1 lbs./gal.)
Mixing Ratio
Add all mortar mix to the polymer
Recommended Dry Film
Thickness (DFT) Per Coat
Will depend on the texture created by the application
Practical Coverage at
Recommended DFT (assumes
15% material loss)
Approximately 125 sq.ft./kit
(23 m
2
/l) for 2 coats
Induction Period
Varies with temperature – see chart in directions
Pot Life @ 70-80°F (21-27°C)
and 50% Rel. Hum.
Varies with temperature – see chart in directions
Dry Times
at 70-80°F
(21-27°C) and
50% Rel. Hum.
Light Traffic
8 hours
Heavy Traffic
24 hours
Vehicle Traffic
4 days
Shelf Life
5 years
Flash Point
Binding Polymer >200°F (93°C)
Safety Information
For additional information, see MSDS
Calculated values are shown and may vary slightly from the actual manufactured material.
*Activated material
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements
of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials
are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to
replacement of defective materials. All technical information is subject to change without notice.