MSDS
Contains crystalline silica as silicon dioxide. Excessive inhalation of respirable crystalline silica dust may cause lung
disease, silicosis or lung cancer. Significant exposure is not anticipated during brush or trowel application or drying.
Risk of overexposure depends on the duration and level of exposure to dust from repeated sanding of surfaces,
mechanical abrasion or spray mist and actual concentration of crystalline silica in the formula. Crystalline silica is
listed as Group 1 "carcinogenic to humans" by the International Agency for Research on Cancer (IARC,) and Group
2, "reasonably anticipated to be a carcinogen" by the National Toxicology Program (NTP)
Primary Route(s) Of Entry: Skin Contact, Skin Absorption, Inhalation, Ingestion, Eye Contact
First Aid - Eye Contact: Hold eyelids apart and flush with plenty of water for at least 15 minutes. Get medical
attention.
First Aid - Skin Contact: Wash with soap and water. Get medical attention if irritation develops or persists.
First Aid - Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give
oxygen. Get immediate medical attention.
First Aid - Ingestion: Do not induce vomiting unless advised by a physician. Call nearest Poison Control Center or
Physician immediately.
Extinguishing Media: Dry Chemical, Foam
Unusual Fire And Explosion Hazards: No unusual Hazards
Special Firefighting Procedures: If water is used, fog nozzles are preferred.
Steps To Be Taken If Material Is Released Or Spilled: Isolate and dispose of in accordance with state and federal
regualtions.
Handling: Use with adequate ventilation.
Storage: Keep container closed when not in use.
Engineering Controls: Provide general dilution of local exhaust ventilation in volume and pattern to keep TLV of
hazardous ingredients below acceptable limits. Use process enclosures, local exhaust ventilation, or other
engineering controls to control airborne levels below recommended exposure limits.
Section 4 - First Aid Measures
Section 5 - Fire Fighting Measures
Flash Point: N.D. F
LOWER EXPLOSIVE LIMIT: N.A. %
(
Setaflash)
UPPER EXPLOSIVE LIMIT
:
N.A. %
Section 6 - Accidental Release Measures
Section 7 - Handling And Storage
Section 8 - Exposure Controls / Personal Protection
Page
2
of
5
245065 Concrete Resurfacer Kit Mortar Mix