Manualshelf

Use and Care Manual

ManualsBrandsRust-Oleum EpoxyShield ManualsPaint2-gal. Tile Red Semi-Gloss Professional Floor Coating Kit (2-Pack)
123
TECHNICAL DATA
EPOXYSHIELD
®
SOLVENT-BASED PROFESSIONAL FLOOR COATING
Rust-Oleum Corporation Form: CS2397
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 030714
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
SOLVENT-BASED PROFESSIONALFLOOR COATING
Resin Type
Amine cured epoxy
Pigment Type
Varies with color
Solvents
N-Butanol, Methyl Isobutyl Ketone, Xylene
Per Gallon
12.1-12.4 lbs.
Per Liter
1.4-1.5 kg
By Weight
82.5-84.7%
By Volume
69.1-72.1%
Volatile Organic Compounds*
<250 g/l (2.08 lbs./gal.)
Mixing Ratio
1:1 Base to Activator (by volume)
Recommended Dry Film
Thickness (DFT) per Coat
3.5-5.0 mils (87.5-125µ)
Wet Film to Achieve DFT (Unthinned
material)
5.0-7.0 mils (125-175µ)
Theoretical Coverage at
1 mil DFT (25µ)
1,108-1,156 sq.ft./gal.
(27.2-28.4 m
2
/l)
Practical Coverage at Recommended
DFT (assume 15% material loss)
150-200 sq.ft./gal.
(3.7-4.9 m
2
/l)
Induction Period
30 minutes @ 70-85°F (21-30°C)
60 minutes @ 60-70°F (15-21°C)
Pot Life @70-80ºF (21-27ºC)
and 50% Relative Humidity
Varies with temperature and gallons mixed– See chart in directions
Lt. Foot Traffic
16 hours
Heavy Ft. Traffic
24 hours
Vehicle Traffic
4 days
Shelf Life
5 years
Flash Point
Base Component 80°F (27°C) – Activator Component 40°F (4°C)
Safety Information
FOR ADDITIONAL INFORMATION, SEE MSDS.
Calculated values may vary slightly from the actual manufactured material.
*Activated material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.