Specification

TECHNICAL DATA ESH-03
EPOXYSHIELD
®®
CONCRETE PATCH & REPAIR KIT
Form: GDH-400
Rev.: 080114
1
DESCRIPTION AND USES .
A two component epoxy based compound designed to repair
cracks and damaged areas on concrete floors. Concrete Patch &
Repair results in an extremely hard surface up to three times
stronger than concrete. No priming is required before applying
floor coatings.
.PRODUCTS .
SKU Description
215173 Concrete Patch & Repair Kit
. APPEARANCE .
Flat gray finish.
.PACKAGING .
Carton contains two plastic tubs with 16 fluid ounces (474
ml) of part B Base and 8 fluid ounces (237 ml) of Part A
Activator.
.PRODUCT APPLICATION .
SURFACE PREPARATION
Allow new concrete to cure for a minimum of 28 days. Concrete
areas which require patching must be free of dirt, oil, grease, and
other contaminates and loose or unsound material. Remove all
dirt, grease, oil, salt and other contaminates by washing the
surface with Rust-Oleum EpoxyShield Heavy Duty Degreaser or
equivalent. Scrape and wire brush to remove loose or unsound
concrete or deteriorated coating.
WARNING! If you scrape, sand or remove old paint, you
may release lead dust. LEAD IS TOXIC. EXPOSURE TO
LEAD DUST CAN CAUSE SERIOUS ILLNESS SUCH AS
BRAIN DAMAGE, ESPECIALLY IN CHILDREN.
PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH-approved respirator to
control lead exposure. Clean up carefully with a HEPA
vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the National
Lead Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead.
.PRODUCT APPLICATION (cont.) .
MIXING
Do not thin. With a clean trowel, spatula, or putty knife, measure
out 2 parts of the Base to 1 part of the Activator onto a flat, clean
piece of cardboard. To avoid cross contamination of unused
material, clean the tool between each use. Mix the two
components together until a uniform gray color and putty-like
consistency is reached. Mix only the amount that can be applied
in 20-30 minutes. Close containers tightly after each use.
APPLICATION
Apply only to a clean, dry area. Using a putty knife or trowel,
apply the mixed Concrete Patch & Repair product evenly over
the surface to be repaired. Allow the product to cure for 8 hours
at 70°F (21°C) and 50% relative humidity before sanding,
cleaning or apply a topcoat.
CLEAN-UP
Wash tools and equipment with xylene, acetone, or
isopropyl alcohol (rubbing alcohol).Properly dispose of all
roller covers and soiled rags.