Use and Care Manual

TECHNICAL DATA
BASEMENT FLOOR COATING
Rust-Oleum Corporation Form: CS1989
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 012513
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
. PHYSICAL PROPERTIES .
* Activated material
Calculated values are shown and may vary slightly from the actual manufactured material
Basement Floor Coating
Resin Type Amine cured epoxy
Pigments Varies with color
Solvents Diethylene Glycol Monomethyl Ether Water
Weight* Per Gallon 9.9-10.1 lbs.
Per Liter 1.18-1.21 kg
Solids* By Weight 44.7-45.3%
By Volume 34.0-34.5%
Volatile Organic Compounds* <250 g/l (2.08 lbs./gal.)
Mixing Ratio 7:1 Base to Activator (by volume) (104 fl. oz to 16 fl. oz.)
Recommended Dry Film
Thickness (DFT) Per Coat
3.0-3.5 mils (75-87.5µ)
Wet Film to Achieve DFT
(Unthinned Material)
9.0-10.0 mils (225-250µ)
Theoretical Coverage at
1 mil DFT (25µ)
545-553 sq.ft./gal.
(13.4-13.6 m
2
/l)
Practical Coverage at
Recommended DFT (assumes 15%
material loss)
150-200 sq.ft./gal.
(3.7-4.9 m
2
/l)
Induction Period 15 minutes
Pot Life at 70-80°F (21-27ºC) and
50% Relative Humidity
16 hours
Dry Times
at
70-80°F
(21-27ºC) and
50% Rel. Hum.
Foot Traffic 24 hours
Vehicle Traffic 3 days
Shelf Life 5 years
Safety
Information
Flash Point
0°F (32°C)
Warning! FOR ADDITIONAL INFORMATION, SEE MSDS.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.