Use and Care Manual

TECHNICAL DATA
BASEMENT FLOOR COATING
Rust-Oleum Corporation Form: GDH-645
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 111416
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
. PHYSICAL PROPERTIES .
* Activated material
Calculated values are shown and may vary slightly from the actual manufactured material
BASEMENT FLOOR COATING
Resin Type
Amine Cured Epoxy
Pigments
Varies with color
Solvents
Dipropylene Glycol Monomethyl Ether, Water
Weight*
Per Gallon
9.9-10.1 lbs.
Per Liter
1.18-1.21 kg
Solids*
By Weight
44.7-45.3%
By Volume
34.0-34.5%
Volatile Organic Compounds*
<250 g/l (2.08 lbs./gal.)
Recommended Dry Film
Thickness (DFT) Per Coat
3.0-3.5 mils
(75-87.5µ)
Wet Film to Achieve DFT
(Unthinned Material)
9.0-10.0 mils
(225-250µ)
Practical Coverage at Recommended DFT
(assumes 15% material loss)
150-200 sq.ft./gal.
(3.7-4.9 m
2
/l)
Induction Period
15 minutes
Pot Life at 70-80°F (21-27°C) and 50% Relative
Humidity
16 hours
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Light Foot Traffic
8 hours
Normal Foot Traffic
24 hours
Shelf Life
5 years
Flash Point
0°F (32°C)
Safety Information
For additional information, see SDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.