MSDS

Date Printed: 5/1/2015
Toluene 108-88-3 25.0 20 ppm N.E. 200 ppm 300 ppm
Titanium Dioxide 13463-67-7 20.0
10 mg/ m3 (Total
Dust)
N.E.
15 mg/ m3 [Total
Dust]
N.E.
Amorphous Silica 7631-86-9 5.0
6 mg/ m3 (NIOSH
REL)
N.E. 80 mg/ m3/ %SiO2 N.E.
PERSONAL PR OTECTION
EN GINEERIN G CON TROLS: Use process enclosures, local exhaust ventilation, or other engineering controls to control airborne
levels below recommended exposure limits. Prevent build-up of vapors by opening all doors and windows to achieve cross-
ventilation.
RESPIRATOR Y PROTECTION: A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2 requirements must
be followed whenever workplace conditions warrant a respirator's use. A NIOSH/MSHA approved air purifying respirator with an
organic vapor cartridge or canister may be permissible under certain circumstances where airborne concentrations are expected to
exceed exposure limits.
Protection provided by air purifying respirators is limited. Use a positive pressure air supplied respirator if there is any potential for
an uncontrolled release, exposure levels are not known, or in any other circumstances where air purifying respirators may not
provide adequate protection.
SKIN PROTECTION: Use gloves to prevent prolonged skin contact. Nitrile or Neoprene gloves may afford adequate skin
protection.
EYE PR OTECTION: Use safety eyewear designed to protect against splash of liquids.
OTH ER PR OTECTIVE EQUIPM EN T: Refer to safety supervisor or industrial hygienist for further guidance regarding types of
personal protective equipment and their applications.
HYGIENIC PRACTICES: Wash thoroughly with soap and water before eating, drinking or smoking. Remove contaminated
clothing immediately and launder before reuse.
9. Physical and Chemical Properties
Appeara n ce : Liquid Ph ysical State: Liquid
Odor: Solvent Like Odor Thre shold : N.E.
Relative D ensi ty: 1.115 pH: N.A.
Fre e ze Point, °C: N.D. Viscosity: No Information
So l u bility in Wate r: Slight Parti tion Coeffi cie n t, n-
octa nol/w a te r:
No Information
Deco m p o sti o n Tem p ., °C: No Information
Bo i ling Range, °C: 223 - 317 Explosive L i m i ts, vo l%: 1.0 - 7.1
Flam m ability: Does not Support Combustion Flash Po i n t, °C: 13
Eva p o ration Rate : Slower than Ether Auto -igniti on Tem p ., °C: No Information
Vapor D e n sity: Heavier than Air Vapor Pre ssure : No Information
(See "Other information" Section for abbreviation legend)
10. Stability and Reactivity
CONDITIONS TO AVOID: Avoid temperatures above 120 ° F. Avoid contact with strong acid and strong bases. Avoid all possible
sources of ignition.
IN COM PATIBILITY: Incompatible with strong oxidizing agents, strong acids and strong alkalies.
HAZARDOU S DECOM POSITION: By open flame, carbon monoxide and carbon dioxide. When heated to decomposition, it
emits acrid smoke and irritating fumes. Contains solvents which may form carbon monoxide, carbon dioxide, and formaldehyde.
HAZARDOU S POLYM ERIZATION : Will not occur under normal conditions.
STABIL ITY: This product is stable under normal storage conditions.
11. Toxicological information
EFFECTS OF OVEREXPOSURE - EYE CON TACT: Causes Serious Eye Irritation
EFFECTS OF OVEREXPOSURE - SKIN CON TACT: May be absorbed through the skin in harmful amounts. Causes skin
irritation. Allergic reactions are possible.
EFFECTS OF OVEREXPOSURE - IN H AL ATION: Harmful if inhaled. High gas, vapor, mist or dust concentrations may be
Page 4 / 7