MSDS

Date Printed: 5/1/2015
HAZARDOU S SU BSTANCES
Chem ica l N a m e CAS-No. Wt.%
Range
GHS Sym bols
GHS Sta tem e n ts
1-Methoxy-2-propyl acetate 25-50 GHS02-GHS06 H226-310108-65-6
Toluene
10-25
GHS02-GHS07-
GHS08
H225-302-332-361-336-373-31
5
108-88-3
Titanium Dioxide 10-2513463-67-7
Amorphous Silica 1.0-2.5 GHS06 H331
7631-86-9
The text for GHS Hazard Statements shown above (if any) is given in the "16. Other Information" section.
4. First-aid Measures
FIR ST AID - EYE CON TACT: Immediately flush eyes with plenty of water for at least 15 minutes holding eyelids open. Get
medical attention. Do NOT allow rubbing of eyes or keeping eyes closed.
FIR ST AID - SKIN CON TACT: Wash skin with soap and water. Remove contaminated clothing. Get medical attention if irritation
develops or persists.
FIR ST AID - IN H AL ATION: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen.
Get immediate medical attention. Do NOT use mouth-to-mouth resuscitation. If you experience difficulty in breathing, leave the
area to obtain fresh air. If continued difficulty is experienced, get medical assistance immediately.
FIR ST AID - IN GESTION : Aspiration hazard: Do not induce vomiting or give anything by mouth because this material can enter
the lungs and cause severe lung damage. Get immediate medical attention. If swallowed, get medical attention.
5. Fire-fighting Measures
EXTIN GUISH ING M EDIA:
Alcohol Film Forming Foam, Carbon Dioxide, Dry Chemical, Dry Sand, Water Fog
UNUSU AL FIRE AN D EXPLOSION H AZAR D S: No unusual fire or explosion hazards noted. Closed containers may explode
when exposed to extreme heat due to buildup of steam. Keep containers tightly closed. Isolate from heat, electrical equipment,
sparks and open flame.
SPECIAL FIREFIGH TIN G PR OCEDURES: Water may be used to cool closed containers to prevent pressure buildup and
possible autoignition or explosion. Evacuate area and fight fire from a safe distance. Use water spray to keep fire-exposed
containers cool. Containers may explode when heated.
6. Accidental Release Measures
STEPS TO BE TAKEN IF M ATERIAL IS R ELEASED OR SPIL L ED: Remove all sources of ignition, ventilate area and
remove with inert absorbent and non-sparking tools. Dispose of according to local, state (provincial) and federal regulations. Do
not incinerate closed containers. Ventilate area, isolate spilled material, and remove with inert absorbent. Dispose of contaminated
absorbent, container, and unused contents in accordance with local, state, and federal regulations.
7. Handling and Storage
HANDLIN G: Wash thoroughly after handling. Wash hands before eating. Remove contaminated clothing and launder before
reuse. Use only with adequate ventilation. Follow all MSDS/label precautions even after container is emptied because it may retain
product residues. Avoid breathing fumes, vapors, or mist. Avoid contact with eyes, skin and clothing.
STORAGE: Product should be stored in tightly sealed containers and protected from heat, moisture, and foreign materials. Store
in a dry, well ventilated place. Keep container tightly closed when not in use. Keep containers tightly closed. Isolate from heat,
electrical equipment, sparks and open flame. Keep away from heat, sparks, flame and sources of ignition. Avoid excess heat. Do
not store above 120 ° F. Store large quantities in buildings designed and protected for storage of NFPA Class II combustible liquids.
8. Exposure Controls/Personal Protection
Chem ica l N a m e CAS-No.
W eight %
Less Than
ACGIH T LV-
TW A
ACGIH T LV-
STEL
OSHA PEL-
TW A
OSHA PEL-
CEILING
1-Methoxy-2-propyl acetate 108-65-6 40.0
50 ppm (AIHA
WEEL)
N.E. N.E. N.E.
Page 3 / 7