MSDS
GM60026A AUTORF 6PK MARKER ULTRA SILVER Page 2 of 5
2
Contains Titanium Dioxide. Titanium Dioxide is listed as a Group 2B-"Possibly carcinogenic to humans" by IARC.
Significant exposure is not anticipated during brush application or drying. Risk of overexposure depends on
duration and level of exposure to dust from repeated sanding of surfaces or spray mist and the actual concentration
of Titanium Dioxide in the formula.
Primary Route(s) Of Entry: Skin Contact, Skin Absorption, Inhalation, Ingestion, Eye Contact
Section 4 – First Aid Measures
First Aid - Eye Contact: Immediately flush eyes with plenty of water for at least 15 minutes holding eyelids open.
Get medical attention. Do NOT allow rubbing of eyes or keeping eyes closed.
First Aid - Skin Contact: Wash with soap and water. Get medical attention if irritation develops or persists.
First Aid - Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give
oxygen. Get immediate medical attention. Do NOT use mouth-to-mouth resuscitation.
First Aid - Ingestion: Aspiration hazard: Do not induce vomiting or give anything by mouth because this material
can enter the lungs and cause severe lung damage. Get immediate medical attention.
Section 5 – Fire Fighting Measures
Flash Point
57°F
Extinguishing Media: Film Forming Foam, Carbon Dioxide, Dry Chemical, Water Fog
Unusual Fire And Explosion Hazards: Vapors may form explosive mixtures with air. Vapors can travel to a source
of ignition and flash back. Isolate from heat, electrical equipment, sparks and open flame.
Special Firefighting Procedures: Water may be used to cool closed containers to prevent pressure buildup and
possible autoignition or explosion. Evacuate area and fight fire from a safe distance.
Section 6 – Accidental Release Measures
Steps To Be Taken If Material Is Released Or Spilled: Eliminate all ignition sources; use explosion-proof
equipment. Place material in a container and dispose of according to local, provincial, state and federal regulations.
Contain spilled liquid with sand or earth. DO NOT use combustible materials such as sawdust.
Section 7 – Handling And Storage
Handling: Wash thoroughly after handling. Follow all MSDS/label precautions even after container is emptied
because it may retain product residues. Use with adequate ventilation. Wash hands before eating.
Storage: Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame. Keep away
from heat, sparks, flame and sources of ignition. Keep container closed when not in use.





