MSDS

Date Printed: 5/5/2015
STORAGE: Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame. Contents under
pressure. Do not store above 120 ° F. Store large quantities in buildings designed and protected for storage of NFPA Class I
flammable liquids. Product should be stored in tightly sealed containers and protected from heat, moisture, and foreign materials.
Store in a dry, well ventilated place. Keep container tightly closed when not in use. Keep away from heat, sparks, flame and sources
of ignition. Avoid excess heat.
8. Exposure Controls/Personal Protection
Chemical Name CAS-No.
Weight %
Less Than
ACGIH TLV-
TWA
ACGIH TLV-
STEL
OSHA PEL-TWA
OSHA PEL-
CEILING
Acetone 67-64-1 35.0 500 ppm 750 ppm 1000 ppm N.E.
Liquefied Petroleum Gas 68476-86-8 30.0 N.E. N.E. N.E. N.E.
Toluene 108-88-3 10.0 20 ppm N.E. 200 ppm 300 ppm
Propylene Glycol Monobutyl
Ether
5131-66-8 10.0 N.E. N.E. N.E. N.E.
n-Butyl Acetate 123-86-4 10.0 150 ppm 200 ppm 150 ppm N.E.
Xylene (mixed isomers) 1330-20-7 5.0 100 ppm 150 ppm 100 ppm N.E.
Aluminum Flake 7429-90-5 5.0 1 mg/m3 N.E.
15 mg/m3 [Total
Dust]
N.E.
1-Methoxy-2-propyl acetate 108-65-6 5.0
50 ppm (AIHA
WEEL)
N.E. N.E. N.E.
Ethyl Acetate 141-78-6 5.0 400 ppm N.E. 400 ppm N.E.
Ethylbenzene 100-41-4 1.0 20 ppm 125 ppm 100 ppm N.E.
PERSONAL PROTECTION
ENGINEERING CONTROLS: Use explosion-proof ventilation equipment. Provide general dilution of local exhaust ventilation in
volume and pattern to keep TLV of hazardous ingredients below acceptable limits. Prevent build-up of vapors by opening all doors
and windows to achieve cross-ventilation. Use process enclosures, local exhaust ventilation, or other engineering controls to control
airborne levels below recommended exposure limits.
RESPIRATORY PROTECTION: A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2 requirements must be
followed whenever workplace conditions warrant a respirator's use. A NIOSH/MSHA approved air purifying respirator with organic
vapor cartridge or canister may be permissible under certain circumstances where airborne concentrations are expected to exceed
exposure limits.
SKIN PROTECTION: Use gloves to prevent prolonged skin contact. Nitrile or Neoprene gloves may afford adequate skin protection.
EYE PROTECTION: Use safety eyewear designed to protect against splash of liquids.
OTHER PROTECTIVE EQUIPMENT: Refer to safety supervisor or industrial hygienist for further guidance regarding types of
personal protective equipment and their applications.
HYGIENIC PRACTICES: Wash thoroughly with soap and water before eating, drinking or smoking. Remove contaminated clothing
immediately and launder before reuse.
9. Physical and Chemical Properties
Appearance:
Aerosolized Mist
Physical State:
Liquid
Odor:
Solvent Like
Odor Threshold:
N.E.
Relative Density:
0.755
pH:
N.A.
Freeze Point, °C:
N.D.
Viscosity:
No Information
Solubility in Water:
Slight
Partition Coefficient, n-octanol/
water:
No Information
Decompostion Temp., °C:
No Information
Boiling Range, °C:
-34 - 999
Explosive Limits, vol%:
0.9 - 14.0
Flammability:
Does not Support Combustion
Flash Point, °C:
-105
Evaporation Rate:
Faster than Ether
Auto-ignition Temp., °C:
No Information
Vapor Density:
Heavier than Air
Vapor Pressure:
No Information
(See "Other information" Section for abbreviation legend)
10. Stability and Reactivity
CONDITIONS TO AVOID: Flammable hydrogen gas will evolve when product comes in contact with water or damp air. Heat will be
generated. The amount of heat generated will depend upon the volume of material in contact. Avoid temperatures above 120 ° F.
Avoid contact with strong acid and strong bases. Avoid all possible sources of ignition.
INCOMPATIBILITY: Incompatible with strong oxidizing agents, strong acids and strong alkalies.
Page 4 / 8