Use and Care Manual

TECHNICAL DATA
AUTOMOTIVE TOUCH-UP AEROSOLS
2 Form: GDH-199
Rev.: 102213
..PRODUCT APPLICATION (cont.) .
SURFACE PREPARATION
Wash the surface with a commercial detergent, or other
suitable cleaning method to remove dirt. Rinse with fresh
water and dry with a clean cloth. For best results, remove
all oil, grease, wax and petroleum based materials with
Rust-Oleum Wax & Tar Remover. Remove loose paint
and rust with a wire brush or sandpaper. Lightly sand
glossy surfaces. WARNING: If you scrape, sand, or remove
old paint, you may release lead dust. LEAD IS TOXIC.
EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS
ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN
CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH-approved respirator to control lead
exposure. Clean up carefully with a HEPA vacuum and a wet
mop. Before you start, find out how to protect yourself and your
family by contacting the National Lead Information Hotline at 1-
800-424-LEAD or log on to www.eps.gov/lead.
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during
use. Hold can 8-10" from surface and spray in a steady
back-and-forth motion, slightly overlapping each stroke.
Keep the can the same distance from the surface and in
motion while spraying. Apply 2 or more light coats a few
minutes apart. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F (21°C) and 50%
relative humidity. Allow more time at cooler temperatures.
Dries to the touch in 30 minutes, to handle in 1 hour and
can be recoated at any time.
CLEAN-UP
Wipe off tip when finished. Clean up wet paint with
acetone or lacquer thinner. Properly discard empty
container. Do not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as acetone or lacquer thinner. Do not insert
any object into can valve opening.