MSDS

Page 3 of 6 Printed 6/6/2012
Section 5 – Fire Fighting Measures
Flash Point
-156 º F
Lower Explosive Limit
1.0%
Upper Explosive Limit
19.0%
Extinguishing Media: Dry Chemical, Foam, Water Fog
Unusual Fire And Explosion Hazards: Perforation of the pressurized container may cause bursting of the
can. Water spray may be ineffective. Closed containers may explode when exposed to extreme heat.
FLASH POINT IS LESS THAN 20 º. F. – EXTREMELY FLAMMABLE LIQUID AND VAPOR!
Vapors may form explosive mixtures with air. Vapors can travel to a source if ignition and flash back.
Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame.
Special Firefighting Procedures: Evacuate area and fight fire from a safe distance.
Section 6 – Accidental Release Measures
Steps To Be Taken If Material Is Released Or Spilled: Remove all sources of ignition; ventilate area and
remove inert absorbent and non-sparking tools. Contain spilled liquid with sand or earth. DO NOT use
combustible materials such as sawdust. Dispose of according to local, provincial, state, and federal
regulations. Do not incinerate closed containers.
Section 7 – Handling And Storage
Handling: Wash hands before eating. Use only in a well-ventilated area. Wash thoroughly after handling.
Avoid breathing vapor or mist. Follow all MSDS/label precautions even after container is emptied because
it may retain product residues.
Storage: Do not store above 120 º F. Store large quantities in buildings designed and protected for storage
of NFPA Class I flammable liquids. Keep containers tightly closed. Isolate from heat, electrical
equipment, sparks and open flame. Contents under pressure. Do not expose to heat or store above 120 º F.
Section 8 – Exposure Controls / Personal Protection
Engineering Controls: Prevent build-up of vapors by opening all doors and windows to achieve cross-
ventilation. Use process enclosures, local exhaust ventilation, or other engineering controls to control
airborne levels below recommended exposure limits. Use explosion-proof ventilation equipment.
Respiratory Protection: A NIOSH/MSHA approved air purifying respirator with an organic vapor
cartridge or canister may be permissible under certain circumstances where airborne concentrations are
expected to exceed exposure limits.
Protection provided by air purifying respirators is limited. Use a positive pressure air supplied respirator if
there is any potential for an uncontrolled release, exposure levels are not known, or any other
circumstances where air purifying respirators may not provide adequate protection. A respiratory
protection program that meets OSHA 1910.134 and ANSI Z88.2 requirements must be followed whenever
workplace conditions warrant a respirator’s use.
Skin Protection: Nitrile or Neoprene gloves may afford adequate skin protection. Use impervious gloves
to prevent skin contact and absorption of this material through the skin.
Eye Protection: Use safety eyewear designed to protect against splash of liquids.
Other protective equipment: Refer to safety supervisor or industrial hygienist for further information