Use and Care Manual

TECHNICAL DATA
ATO-135
RUST-OLEUM
®
VINYL WRAP
1
Form: ARJ-1972
Rev.: 012320
DESCRIPTION AND USES
Rust-Oleum
®
Vinyl Wrap is a removable vinyl coating that
provides endless customization for automotive and other
applications. It provides a smooth, glossy finish with
premium performance and protection from road debris and
gasoline. This all-weather coating is great for use on metal,
OEM clear coat, glass and more. Vinyl Wrap can be
removed when no longer needed or desired.
NOTE: NOT RECOMMENDED FOR USE ON PLASTICS.
This product may not be compatible with all surfaces and all
conditions surrounding application. Before applying to any
surface, always test product in a small, inconspicuous area.
PRODUCTS
SKU
DESCRIPTION (AEROSOL)
352724
Gloss Black
352725
Gloss White
352726
Gloss Red
PRODUCT APPLICATION
READ ALL INSTRUCTIONS CAREFULLY BEFORE
STARTING PROJECT
APPLICATION CONDITIONS
Use outdoors or in a well-ventilated area such as an open
garage. Use when temperature is between 50°-90°F
(10°C-32°C) and humidity is below 65% to ensure proper
drying. Do not apply to galvanized metal. Not recommended
for automotive surfaces with a damaged OEM finish. Avoid
spraying in very windy, dusty conditions. Cover surrounding
area to protect from spray mist.
SURFACE PREPARATION
Thoroughly wash surface with soap and water prior to
application. Let dry. Priming is not required or
recommended.
PRODUCT APPLICATION (cont.)
APPLICATION
Shake can vigorously for one minute after mixing ball begins
to rattle. If mixing ball fails to rattle DO NOT STRIKE.
Contact Rust-Oleum. Shake often during use. Keep the can
8-12” from surface and spray in a steady back-and-forth
motion, slightly overlapping each stroke. Apply 4 or more
light coats to build desired coating thickness, followed by 1
or more medium coat(s) to achieve a smooth final film.
NOTE: Target 50% coverage on first coat. Allow coating to
dry for about 5 minutes between coats. More coats will result
in a thicker coating which is easier to remove when desired.
Allow coating to cure for 48 hours prior to washing.
DRY & RECOAT
Dry and recoat times are based on 70°F (20°C) and 50%
relative humidity. Allow more time at cooler temperatures.
Dries to the touch in 30 minutes, to handle in 2 hours.
REMOVAL
You can peel film off once the coating has fully cured. This
coating has been formulated for temporary use and is
recommended to be removed within 6 months or less. A
microfiber cloth or acetone may assist in the removal of
coating in intricate areas
CLEAN-UP
When finished spraying, clear spray valve by turning can
upside down and pushing spray button for 5 seconds. Allow
wet paint to dry, once dry, peel away or clean up with
acetone. Throw empty cans in trash pickup. Do not burn or
place in home compactor.
CLOGGING
If valve clogs, twist and pull off spray tip and rinse it in a
solvent such as acetone. Do not stick a pin or other objects
into the stem.