Use and Care Manual

TECHNICAL DATA
PCG-08
PEEL COAT
®
RUGGED COAT
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 877∙385∙8155
www.rustoleum.com
Form: GDH-1226
Rev.: 020519
PHYSICAL PROPERTIES
PEEL COAT RUGGED COAT
Resin Type
Synthetic Rubber
Pigment Type
Varies with color
Solvents
Blend of Acetates, Aliphatic and Aromatic Hydrocarbons
MIR
1.60 Max
Fill Weight
10 ounces
Recommended Dry Film
Thickness (DFT) Per Coat
0.5-1.0 mils
(12.5-25µ)
Practical Coverage
at Recommended DFT
8.0 sq.ft./can
(0.75 m
2
/can)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
20 minutes
Handle
1 hour
Recoat
20 minutes
Shelf Life
3 years
Flash Point
-156°F (-104°C)
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.