Use and Care Manual

TECHNICAL DATA
SRT-50
TRUCK BED PRO GRADE
WITH TURBO SPRAY SYSTEM
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 888∙855∙8430
www.rustoleum.com
Form: ARJ-1719
Rev.: 121018
PHYSICAL PROPERTIES
TRUCK BED PRO GRADE WITH TURBO SPRAY SYSTEM
Resin Type
Mixture of hydrocarbon and SEBS polymers
Pigment Type
Inorganic filler pigments
Solvents
VM&P Naptha, Xylene, N-butyl acetate, Methyl n-amyl ketone, Dimethyl
Carbonate, Ethyl acetate, Propylene Carbonate
MIR
1.02 Max
Fill Weight
24 ounces
Recommended Dry Film Thickness
(DFT) Per Coat
3.0-4.0 mils
(75-100µ)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
15 sq.ft./can
Dry Times at 77°F
(25°C) and 50%
Relative Humidity
Touch
1 hour
Handle
1 hour
Recoat
30 minutes
Dry Heat Resistance
265°F (130°C)
Shelf Life
5 years
Flash Point
-141°F (-96°C)
Safety Information
For additional information, see SDS.
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.