SDS

Date Printed: 12/22/2016
FIRST AID - INHALATION: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get
immediate medical attention. Do NOT use mouth-to-mouth resuscitation. If you experience difficulty in breathing, leave the area to
obtain fresh air. If continued difficulty is experienced, get medical assistance immediately.
FIRST AID - INGESTION: Aspiration hazard: Do not induce vomiting or give anything by mouth because this material can enter the
lungs and cause severe lung damage. Get immediate medical attention. If swallowed, get medical attention.
5. Fire-fighting Measures
EXTINGUISHING MEDIA: Alcohol Film Forming Foam, Carbon Dioxide, Dry Chemical, Dry Sand, Water Fog
UNUSUAL FIRE AND EXPLOSION HAZARDS: FLASH POINT IS LESS THAN 20°F. EXTREMELY FLAMMABLE LIQUID AND
VAPOR!Water spray may be ineffective. Closed containers may explode when exposed to extreme heat due to buildup of steam.
Closed containers may explode when exposed to extreme heat. Vapors may form explosive mixtures with air. Vapors can travel to a
source of ignition and flash back. Isolate from heat, electrical equipment, sparks and open flame. Perforation of the pressurized
container may cause bursting of the can. No unusual fire or explosion hazards noted. Keep containers tightly closed.
SPECIAL FIREFIGHTING PROCEDURES: Full protective equipment including self-contained breathing apparatus should be used.
Evacuate area and fight fire from a safe distance. Water may be used to cool closed containers to prevent pressure buildup and
possible autoignition or explosion. Use water spray to keep fire-exposed containers cool. Containers may explode when heated.
6. Accidental Release Measures
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Contain spilled liquid with sand or earth. DO NOT use
combustible materials such as sawdust. Isolate the hazard area and deny entry to unnecessary and unprotected personnel. Remove
all sources of ignition, ventilate area and remove with inert absorbent and non-sparking tools. Dispose of according to local, state
(provincial) and federal regulations. Do not incinerate closed containers. Ventilate area, isolate spilled material, and remove with
inert absorbent. Dispose of contaminated absorbent, container, and unused contents in accordance with local, state, and federal
regulations.
7. Handling and Storage
HANDLING: Wash thoroughly after handling. Wash hands before eating. Remove contaminated clothing and launder before reuse.
Use only with adequate ventilation. Follow all MSDS/label precautions even after container is emptied because it may retain product
residues. Avoid breathing fumes, vapors, or mist. Avoid contact with eyes, skin and clothing.
STORAGE: Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame. Contents under
pressure. Do not store above 120 ° F. Store large quantities in buildings designed and protected for storage of flammable aerosols.
Product should be stored in tightly sealed containers and protected from heat, moisture, and foreign materials. Store in a dry, well
ventilated place. Keep container tightly closed when not in use. Keep away from heat, sparks, flame and sources of ignition. Avoid
excess heat.
8. Exposure Controls/Personal Protection
Chemical Name CAS-No.
Weight %
Less Than
ACGIH TLV-
TWA
ACGIH TLV-
STEL
OSHA PEL-TWA
OSHA PEL-
CEILING
Naphtha, Petroleum,
Hydrotreated Light
64742-49-0 30.0 N.E. N.E. N.E. N.E.
Propane 74-98-6 15.0 N.E. N.E. 1000 ppm N.E.
Heptane, branched, cyclic and
linear
426260-76-6 10.0 N.E. N.E. N.E. N.E.
Hydrotreated Light Distillate 64742-47-8 10.0 N.E. N.E. N.E. N.E.
n-Butane 106-97-8 10.0 N.E. 1000 ppm N.E. N.E.
tert-Butyl Acetate 540-88-5 10.0 50 ppm 150 ppm 200 ppm N.E.
Xylenes (o-, m-, p- isomers) 1330-20-7 5.0 100 ppm 150 ppm 100 ppm N.E.
Titanium Dioxide 13463-67-7 5.0 10 mg/m3 N.E. 15 mg/m3 N.E.
Ethylbenzene 100-41-4 5.0 20 ppm N.E. 100 ppm N.E.
bis(1,2,2,6,6-Pentamethyl-4-
Piperidinyl) Sebacate
41556-26-7 1.0 N.E. N.E. N.E. N.E.
Stoddard Solvent 8052-41-3 1.0 100 ppm N.E. 500 ppm N.E.
Naphtha (Petroleum), Heavy
Alkylate
64741-65-7 1.0 N.E. N.E. N.E. N.E.
Ethanol 64-17-5 1.0 N.E. 1000 ppm 1000 ppm N.E.
Methanol 67-56-1 1.0 200 ppm 250 ppm 200 ppm N.E.
PERSONAL PROTECTION
Page 3 / 6