Use and Care Manual

TECHNICAL DATA
PROFESSIONAL GRADE TRUCK BED LINER KIT
Form: GDH-39
Rev.: 042913
2
.PRODUCT APPLICATION (CONT.)
Starting at the front wall (wall by the cabin) begin applying
the coating to all corners and hard to reach areas using a
brush. Apply with dabbing motion. DO NOT USE A
BRUSHING MOTION. After the first coat is applied, apply
a second coat after the first coat has begun to “tack up”
(approximately 15-30 minutes). Allow additional time
between coats if the temperature is between 50-60°F (10-
15°C).
When all the corners and hard to reach areas have been
brushed (cut-in) start applying the first coat to the side
walls of the truck bed using the supplied roller. Starting on
one side, slowly work your way from the back (closest to
tailgate) moving to the front, then down the opposite side.
After the first coat is applied, apply a second coat after the
first coat has begun to “tack up” (approximately 15-30
minutes). Allow additional time between coats if the
temperature is between 50-60°F (10-15°C).
When the side walls are complete, start painting at the
front of the bed (wall by the cab). Roll on the coating only
as far as you can comfortably reach. Apply a second coat
as outlined above. Continue applying the coating to the
remainder of the truck bed in the same manner, allowing
15 minutes between coats. Be sure to include the tailgate.
Apply a second as outlined above. After the coating has
been applied, do not expose to temperatures below 50°F
(10°C) for 24 hours. Following application, immediately
remove all masking tape, pulling it off slowly to avoid
disturbing the edges of the coating. The earlier the tape is
removed, the easier it will be to remove.
DRYING TIME
Allow the coating to dry for 24-48 hours before subjecting
to light duty. Do not throw or drag heavy or sharp items in
the truck bed until fully cured (7 days).
CLEAN UP
Clean tools and equipment immediately after use with
Rust-Oleum Acetone or xylene. Clean-up wet paint with
Rust-Oleum Acetone or xylene. If you have material left
over when you are finished, allow the material to harden in
the can, then dispose of properly.
.