Specification

TECHNICAL DATA ATO-95
UNIVERSAL BONDING PRIMER
Form: GDH-621
Rev.: 042415
1
.DESCRIPTION AND USES .
Rust-Oleum
®
Universal Bonding Primer is a fast dry, maximum
adhesion white primer that firmly bonds any topcoat to difficult-to-
paint surfaces, including two part epoxies. It may be used on
interior or exterior surfaces to include galvanized steel, wrought
iron railings, furniture, aluminum flashings, PVC, porcelain,
masonry, glazed brick, metal, wood, fiberglass and other
surfaces.
Universal Bonding Primer features an advanced spray system
that allows you to spray at any angle, even upside down for
those hard to reach areas. A comfort spray tip with a wider finger
pad reduces fatigue caused by continuous spraying.
.PRODUCTS .
SKU (12 ounce spray) Description
286793 White Bonding Primer
..PRODUCT APPLICATION .
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50-90°F (10-
32°C) and humidity is below 85% to ensure proper drying.
Do not apply to surfaces that, when heated, exceed 200°F
(93°C). Avoid spraying in very windy and dusty conditions.
Cover surrounding area to protect from spray mist.
SURFACE PREPARATION
Wash the surface with a commercial detergent, or other
suitable cleaning method to remove dirt. Rinse with fresh
water and let dry. Remove all oil, grease, wax and
petroleum based materials with mineral spirits. Remove
loose paint and rust with a wire brush or sandpaper.
Lightly sand glossy surfaces.
WARNING: If you scrape, sand, or remove old paint, you may
release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD
DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN
DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN
SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved
respirator to control lead exposure. Clean up carefully with a
HEPA vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the National Lead
Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead.
..PRODUCT APPLICATION (cont.) .
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during
use. Hold can 12" from surface and spray in a steady
back-and-forth motion, slightly overlapping each stroke.
Keep the can the same distance from the surface and in
motion while spraying. Apply 2 or more light coats a few
minutes apart. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F (21°C) and 50%
relative humidity. Allow more time at cooler temperatures.
Dries to the touch in 30 minutes and dries to handle in 1
hour. Apply a second coat or topcoat at anytime. For two
part epoxies, wait two hours before topcoating.
CLEAN-UP
Wipe off tip when finished. Clean up wet paint with xylene
or mineral spirits. Properly discard empty container. Do
not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into can valve opening.