Use and Care Manual

TECHNICAL DATA
STAINLESS STEEL
Rust-Oleum Corporation Form: GDH-410
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 080514
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
STAINLESS STEEL
Resin Type
Epoxy Ester Chain Stopped Alkyd
Pigment Type
Aluminum Flake
Solvents
Acetone, Butyl acetate, Toluene, Xylene
MIR
1.90 Max
Fill Weight
11 ounces
Recommended Dry Film
Thickness (DFT) Per Coat
2.0 mils
(50µ)
Practical Coverage
at Recommended DFT
10-12 sq. ft./can
(0.90-1.10 m
2
/can)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
2-4 hours
Handle
5-9 hours
Recoat
Within ½ hour or after 1 week
Fully Dry
24 hours
Dry Heat Resistance
250°F (121°C)
Shelf Life
5 years
Flash Point
-156°F (-104°C)
Safety Information
For additional information, see MSDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.