Use and Care Manual

TECHNICAL DATA ATO-89
EPOXY PAINT
Form: GDH-406
Rev.: 080514
1
.DESCRIPTION AND USES .
Rust-Oleum
®
Epoxy Paint is a one step epoxy coating that does
not require a primer. It gives the appearance of a tough baked-on,
porcelain-like finish that provides excellent corrosion resistance. It
is suitable for use on metal, aluminum, fiberglass and plastic.
Epoxy Paint features an advanced spray system that allows you
to spray at any angle, even upside down for those hard to reach
areas. A comfort spray tip with wider finger pad reduces fatigue
caused by continuous spraying.
.PRODUCTS .
SKU (11 ounce spray) Description
263376 Black
..PRODUCT APPLICATION .
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50-90°F (10-
32°C) and humidity is below 65% to ensure proper drying.
Not intended for continuous water submersion or for
surfaces that, when heated, exceed 250°F (121°C). Do not
use on galvanized steel. Priming is not recommended.
Avoid spraying in very windy and dusty conditions. Cover
surrounding area to protect from spray mist. Do not use on
stove tops, oven interiors or objects exposed to heat.
SURFACE PREPARATION
Wash the surface with a commercial detergent, or other
suitable cleaning method. Rinse with fresh water and dry
with a clean cloth. Remove loose paint and rust with a wire
brush or sandpaper. Lightly sand glossy surfaces.
WARNING: If you scrape, sand, or remove old paint, you may
release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD
DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN
DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN
SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved
respirator to control lead exposure. Clean up carefully with a
HEPA vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the National Lead
Information Hotline at 1-800-424-LEAD or log on to
www.eps.gov/lead.
..PRODUCT APPLICATION (cont.) .
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during
use. Hold can 12-16" from surface and spray in a steady
back-and-forth motion, slightly overlapping each stroke.
Keep the can the same distance from the surface and in
motion while spraying. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F (21°C) and 50%
relative humidity. Allow more time at cooler temperatures.
Dries to the touch in 2-4 hours, to handle in 5-9 hours and
is fully dry in 24 hours. May recoat within ½ hour or after 1
week.
CLEAN-UP
Wipe off tip when finished. Clean up wet paint with xylene
or mineral spirits. Properly discard empty container. Do
not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into can valve opening.