Use and Care Manual

TECHNICAL DATA
AUTOMOTIVE PAINT FOR PLASTIC CLEAR
Rust-Oleum Corporation Form: GDH-408
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 080514
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
PAINT FOR PLASTIC
Resin Type
Acrylic
Pigment Type
NA
MIR
1.50 Max
Fill Weight
11 ounces
Solvents
Acetone, Butyl Acetate, Naphtha, Toluene
Recommended Dry Film
Thickness (DFT) Per Coat
1.0-2.0 mils
(25-50µ)
Practical Coverage
at Recommended DFT
8-15 sq. ft./can
(0.90-1.4 m
2
/can)
Dry Times
at 77°F (25°C)
and 50%
Rel. Hum.
Touch
20-30 minutes
Handle
1 hour
Recoat
Anytime
Shelf Life
5 years
Flash Point
-156°F (-104°C)
Safety Information
For additional information, see MSDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.