Use and Care Manual

TECHNICAL DATA
AUTOMOTIVE PRIMER SURFACER
Rust-Oleum Corporation Form: GDH-742
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 031015
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
PRIMER SURFACER
Resin Type
Alkyd Modified acrylic
Pigment Type
Carbon Black
Solvents
Acetates and Aromatic Hydrocarbons
Weight
Per Gallon
11.0 lbs./gal.
Per Liter
1.31 kg
Solids
By Weight
60.8%
By Volume
40.7%
Volatile Organic Compounds
516 g/l (4.3 lbs./gal.)
Recommended Dry Film Thickness
(DFT) per Coat
1.5-2.0 mils
(37.5-50µ)
Wet Film to Achieve DFT
(thinned 1:1 with Specialty Reducer)
7.5-10.0 mils
(187.5-250µ)
Theoretical Coverage at 1 mil DFT (25µ)
652 sq.ft./gal.
(16.0 m
2
/l)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
40-50 sq.ft./qt. (3.9-4.9 m
2
/l)
Thinned 1:1 with Specialty Reducer
Dry Times at 70-80°F
(21-25°C) and 50%
Relative Humidity
Touch
10-15 minutes
Handle
20 minutes
Block Sand
60-90 minutes
Dry Heat Resistance
200ºF (93ºC)
Shelf Life
5 years
Flash Point
35ºF (2ºC)
Safety Information
For additional information, see MSDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.