Use and Care Manual
TECHNICAL DATA ATO-58
2 in 1 FILLER & SANDABLE
PRIMER
Form: GDH-111
Rev.: 071613
1
.DESCRIPTION AND USES .
Rust-Oleum
®
Filler Primer is a hi-build formula that fills in minor
imperfections in the surface and improves topcoat adhesion and
appearance. This product is suitable for use on metal, wood and
fiberglass surfaces. Filler Primer features an advanced spray
system that allows you to spray at any angle, even upside down
for those hard to reach areas. A comfort spray tip with a wider
finger pad reduces fatigue caused by continuous spraying.
.PRODUCTS .
SKU (11 ounce spray) Description
249320 Red
249279 Gray
..PRODUCT APPLICATION .
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50-90°F (10-
32°C) and humidity is below 85% to ensure proper drying.
Do not apply to surfaces that, when heated, exceed 200°F
(93°C) or galvanized metal. Avoid spraying in very windy
and dusty conditions. Cover surrounding area to protect
from spray mist.
SURFACE PREPARATION
Wash the surface with a commercial detergent, or other
suitable cleaning method. Rinse with fresh water and dry
with a clean cloth. Remove loose paint and rust with a wire
brush or sandpaper. Lightly sand glossy surfaces.
WARNING: If you scrape, sand, or remove old paint, you may
release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD
DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN
DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN
SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved
respirator to control lead exposure. Clean up carefully with a
HEPA vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the National Lead
Information Hotline at 1-800-424-LEAD or log on to
www.eps.gov/lead.
..PRODUCT APPLICATION (cont.) .
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during
use. Hold can 12-16" from surface and spray in a steady
back-and-forth motion, slightly overlapping each stroke.
Keep the can the same distance from the surface and in
motion while spraying. Apply 2 or more light coats a few
minutes apart. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F (21°C) and 50%
relative humidity. Allow more time at cooler temperatures.
Dries to the touch in 10 minutes. When dry, the surface
can be immediately recoated, top coated or wet sanded.
For best results, allow to dry 2-4 hours before dry sanding.
CLEAN-UP
Wipe off tip when finished. Clean up wet paint with xylene
or mineral spirits. Properly discard empty container. Do
not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into can valve opening.