Use and Care Manual

ManualsBrandsRust-Oleum Automotive ManualsPaint18 oz. Aircraft Remover (6-Pack)

SPRAY TECHNICAL DATA ATO

-31

AUTOMOTIVE

AIRCRAFT REMOVER

Form: RAC-17

Rev.: 011813

].DESCRIPTION AND USES .

Rust-Oleum

Aircraft Remover is a fast acting remover

that strips finishes from metal automotive surfaces. Use

Aircraft Remover to quickly remove acrylics, lacquers,

polyurethane and baked enamels from automobiles and

trucks in 5 minutes which leaves a bare surface that is

ready to be primed or painted. Not recommended for use

on fiberglass, plastics, or any other synthetic surface. This

product is non-corrosive to all common metals under

normal exposure time. Protect hands with solvent-resistant

gloves and eyes with chemical splash goggles.

.PRODUCTS .

18-ounce Spray Description

255449 Aircraft Remover

248872 Aircraft Remover

.PRODUCT APPLICATION .

APPLICATION

Remove or protect any portions of the vehicle not being

stripped. Mask seams and trim openings as this will

prevent bleed-back stripping of new finish. Shake well

before using. Hold can in an upright position and point

arrow on top of button away from you. Spray at a distance

of approximately 10-16" from surface. To avoid sagging on

vertical surfaces, use a back and forth motion to apply a

generous even coat. Limit work area to one section at a

time, such as a hood. Let the remover stand until finish is

completely blistered or softened completely, generally in

15 minutes. Remove paint with a flexible plastic scraper

and then flush with solvent or water to remove any residue.

Allow surface to dry before applying a new finish. The

metal should be primed as soon as possible to prevent

flash rust.

NOTE: This product may not be compatible with all

surfaces and all conditions surrounding the application.

Before applying to any surface, always test product in a

small inconspicuous area to ensure no damage will result.

This product is not recommended for use on fiberglass,

plastics or any other synthetic surface. For best results,

apply at temperatures between 65-90°F (18-32°C) and

avoid direct sunlight or strong breezes.

CLOGGING

If the valve clogs, twist and pull off spray tip and rinse in a

solvent such as mineral spirits. Do not insert any object

into can valve opening.

Summary of content (2 pages)

PAGE 1
SPRAY TECHNICAL DATA ATO-31 AUTOMOTIVE AIRCRAFT REMOVER ].DESCRIPTION AND USES .PRODUCT APPLICATION . APPLICATION ® Rust-Oleum Aircraft Remover is a fast acting remover that strips finishes from metal automotive surfaces. Use Aircraft Remover to quickly remove acrylics, lacquers, polyurethane and baked enamels from automobiles and trucks in 5 minutes which leaves a bare surface that is ready to be primed or painted. Not recommended for use on fiberglass, plastics, or any other synthetic surface.
PAGE 2
TECHNICAL DATA AUTOMOTIVE ENAMEL SPRAY PHYSICAL t Physical Properties Solvents Aircraft Remover Blend of Methanol, Ethanol, Methylene Chloride, Mineral Spirits, and Toluene MIR 0.50 Max Fill Weight 18 ounces Shelf Life 5 years Flash Point -156°F (-104°C) Safety Information For additional Information, see MSDS. The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith.