Use and Care Manual

TECHNICAL DATA
HIGH HEAT PRIMER
Rust-Oleum Corporation Form: GDH-109
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 071613
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
HIGH HEAT PRIMER
Resin Type
Proprietary
Pigment Type
Titanium Dioxide, Copper Chromite Black
Solvents
Acetone, Toluene, Xylene
MIR
1.70 Max
Fill Weight
12 ounces
Recommended Dry Film
Thickness (DFT) Per Coat
1.5-2.5 mils (37.5-62.5µ)
Practical Coverage
at Recommended DFT
10-12 sq. ft./can
(0.90-1.09 m
2
/can)
Dry Times
at 70°F (21°C)
and 50% Relative
Humidity
Touch
30 minutes
Handle
1-2 hours
Cure
See instructions on previous page
Dry Heat Resistance
2,000°F (1093°C) Intermittent
Shelf Life
5 years
Flash Point
-156°F (-104°C)
Safety Information
For additional information, see MSDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.